Home
Catalogue
Why Us Enquiry Feedback

Products
  Aluminium
  Brass
  Naval Brass
  Bronze
Aluminium Bronze
  Phosphorus Bronze
  ETP Copper
  OFC Copper
  Copper Pipes and Fittings
  Stainless Steel
  Lead
  Perforated Sheets
  Wire Mesh
 
 
 

 

ALUMINIUM BRONZE

General Properties :

  • Specifications : C95210 , C95400, C95810
  • Typical Chemical Composition (C95210 / AB1 / CuAl10Fe):
    • Cu: >86.0%
    • Al: 8.5%~9.5%
    • Sn: <0.1%
    • Zn: <0.5%
    • Ni: <1.0%
    • Pb: <0.05%
    • Fe: 2.5%~4.0%
    • Mn: <1.0%
  • Typical Mechanical Properties (C95210 / AB1 / CuAl10Fe):
    • Tensile Strength 490 N/mm2
    • Elongation 20 %
    • Typical Hardness 90 HB
    • 0.2% Yield Strength 170 N/mm2
  • Typical Chemical Composition (C95400 / AB1 / DIN CuAl10Fe):
    • Cu: >83.0%
    • Al: 10.0%~11.5%
    • Ni: 1.0% ~ 3.0%
    • Fe: 3.0%~5.0%
    • Mn: <0.5%
  • Typical Mechanical Properties (C95400 / AB1 / DIN CuAl10Fe):
    • Tensile Strength 540 N/mm2
    • Elongation 15 %
    • Typical Hardness 120 HB
    • 0.2% Yield Strength 220 N/mm2
  • Typical Chemical Composition (C95810 / AB2 / DIN CuAl10Ni):
    • Cu: >79.0%
    • Al: 8.5%~9.5%
    • Sn: <0.1%
    • Zn: <0.5%
    • Ni: 4.0%~5.0%
    • Pb: <0.05%
    • Fe: 3.5%~4.5%
    • Mn: 0.8~1.5%
  • Typical Mechanical Properties (C95810 / AB2 / DIN CuAl10Ni):
    • Tensile Strength 610 N/mm2
    • Elongation 12 %
    • Typical Hardness: 160 HB
    • 0.2% Yield Strength: 245 N/mm2
  • This group of alloys combines high mechanical strength and hardness with the ability to resist corrosion by a large variety of agents.
  • Corrosion resistant suitable for marine, oil and chemical uses.
  • Excellent hot working properties, resistance to oxidation at elevated temperatures, good wearing qualities and a low coefficient of friction are some of the features of these alloys.

Profiles available:

  • Flat Bar / Bus Bar
  • Round Bar / Rod
  • Sheet / Plate


Email us for more information on this product.

Disclaimer: All details are given in good faith and have been carefully checked. The values listed above represent reasonable approximations suitable for general engineering use. Due to commercial variations in composition and to manufacturing limitations, they should NOT be used for specification purposes. Only the full mill certificate can be accepted as accurate information regarding the properties of the metal supplied by TLM.